The fully automatic tile press machine manually places and removes the blanks. The work procedure: before using the equipment, check whether the connections are firm and whether the mounting bolts and nuts are tightened. Enough lubricating oil should be added to the left and right chassis before the machine can be powered on and started for test run. Observe carefully when the empty car is running to see if there are any vibrations and noises, whether there is oil coming from the oil window, and whether the movement of each component is coordinated. The mold can be installed only after everything is normal. When installing the mold, the power must be cut off, and the motor belt or large gear must be moved by hand. When the worktable is rotated and the sliding seat is raised to the highest point, it is best to use an object to support it between the workbench and the bottom of the sliding seat to prevent the sliding seat from falling naturally and causing an accident. The mold used in this machine requires an upper mold and six lower molds of the same size. Install the upper mold and a lower mold first. The lower mold is directly installed on the hexagonal runner worktable, and the upper mold is installed on the bottom of the slide. Place a backing plate of appropriate thickness to ensure that after the upper and lower molds are closed, the surrounding gaps are even and the distance between the upper and lower molds is equal to the required thickness of the tile blank. Then take the upper mold as the standard, turn the workbench, and install the remaining five sets of lower molds. Only after the upper and lower molds are installed can the car be driven for tile pressing.

Automatic unloading and billet removal working procedures: Mold installation and host test run are the same as above, then start the air compressor, vacuum pump, extruder, tile cutting machine, unloading machine, tile press, host and tile conveyor, when parking , stop the extruder first, and then stop the other equipment.