Debugging steps for Wall Sheet Roll Forming Machine

1. When adjusting the equipment of the tile press, cut off the power supply and pay attention to the safety of your hands when moving the workpiece.

2. All parts of the machine tool should be regularly lubricated. The operator should add lubricating oil once per shift, and the mechanic should add lubricating oil to the rotating bearing parts once every six months. The upper blade of the shearing machine is fixed on the tool holder, and the lower blade is fixed on the workbench. A holding ball is installed on the workbench to prevent the sheet from being scratched when sliding on it. . The pressing cylinder is used to compress the sheet to prevent the sheet from moving during shearing. Guardrails are safety devices to prevent workplace injuries. .

Shearing machine safety regulations:

3. Wear tight-fitting protective clothing before operation, with cuffs fastened, and the hem of the coat cannot be opened. Do not put on or take off clothing next to a running machine tool, or wrap it around the body to avoid equipment strangulation. Wear a safety hat and put your braids inside the hat. Skirts and slippers are not allowed. After shearing, the shearing machine should be able to meet the straightness and parallelism requirements of the shearing surface of the sheared sheet, and try to reduce the distortion of the sheet, so that the back gauge of the workpiece obtained is used for sheet positioning. The position is adjusted by the motor and the return stroke is generally Nitrogen, small impact.

4. This machine tool is suitable for cutting various steel plates, copper plates, aluminum plates and non-metallic material plates whose thickness is the rated value of the machine tool. It is also a material without hard marks, welding slag, slag inclusions and welds. Over-thickness is not allowed.

5. Usage methods of this machine tool: a. Adjust the blade gap according to the thickness of the material to be cut.

6. The operator of this machine tool is familiar with the main structure, performance and application method of the shearing machine. b. Adjust the template or fixture according to the width of the material to be sheared. c. Make 1-3 empty strokes before operating the machine tool, and then shearing work can be carried out only after it is normal.

7. If the equipment is found to be operating abnormally during use, immediately cut off the power supply and shut down for inspection.