The Color steel tile veneer machine mainly consists of left and right bodies,bottom connecting rod,top chassis cover,sliding seat,hexagonal runner,pulley,gear mechanism,sheave mechanism,cam mechanism,lubrication pump,oil circuit system,electronic control part,etc.composition.

The indexing positioning of the workbench is accomplished by a gear set installed at the end of the upper shaft,a driving pin gear,and a sheave wheel installed on the hexagonal runner shaft to complete the indexing positioning.There is a gear set at each end of the upper shaft.The return cam conjugated with the control cam on the same axis achieves the accurate positioning of the lower mold in the working position through the positioning rod and positioning plate.Lubricating pumps are installed in the left and right sides of the chassis.When the machine is operating,the oil pipes transport lubricating oil to various frictional moving parts.

It is forbidden to operate at a small closing height,that is,the minimum distance from the bottom of the upper sliding box to all working surfaces is 290mm.It is required to add the height after the upper and lower molds are closed,the thick bottom of the upper and lower backing plates plus the thickness of the tile blank.290mm is not allowed.When making the mold,it should be Describe according to this requirement to avoid machine tool accidents.Always pay attention to observe the height of lubricating oil in the sliding box and both sides of the machine.

The Color steel tile veneer machine equipment should be scrubbed frequently to keep it clean,and no mud or water is allowed.The upper die stamping process of this machine:the motor drives the input shaft through the pulley,drives the upper shaft through the pinion gear,the large gear,and drives the sliding seat equipped with the upper die to move up and down through a set of cam mechanism to complete the pressing of the tiles.