For the use and maintenance of the Double Layer Roll Forming Machine, the Double Layer Roll Forming Machine equipment must not only be used but also maintained. Proper maintenance methods can greatly extend the life of the tile press equipment. Usually, when we use it, we should pay attention to the operation process of the tile press equipment to see if it is the same as the previous operation and whether there is any difference. If so, we must check clearly what the reason is and solve it in time. problems arise. We need to frequently check whether each component is stable, and clean all parts frequently, especially the fuel tank and oil filter equipment to keep the oil pipes smooth.

During the use of color steel equipment, we must pay attention to the operation of the tile press, and solve problems when we find them. Don't think that the problem is small and do not solve it. Sometimes small problems can lead to big failures. For the maintenance of the tile press, it is necessary to formulate a plan and achieve regular maintenance. Proper maintenance of the Double Layer Roll Forming Machine will play a big role in extending the life of the tile press. Tile press users must not underestimate the importance of maintenance of the tile press.

First of all, the surface of the Double Layer Roll Forming Machineing machine must be cleaned. The upper die stamping process of the machine is as follows: the motor drives the input shaft through the pulley, through the pinion and the large gear, drives the upper shaft, and drives the upper shaft equipped with the upper die through a set of cam mechanism. The sliding seat moves up and down to press the tiles.

The indexing positioning of the worktable of the Double Layer Roll Forming Machine is achieved by a gear set mounted on the end of the upper shaft, a driving pin gear, and a sheave wheel mounted on the hexagonal runner shaft to achieve indexing positioning. Each is equipped with a return cam that is mounted on the same axis and is conjugate to the pressing cam. The lower mold is accurately positioned in the working position through the positioning rod and positioning plate. Lubricating pumps are installed in the chassis on the left and right sides. When the machine is working, the oil pipes pass by and deliver lubricating oil to various friction moving parts. Persons who understand the structure, performance and operating procedures of this machine are not allowed to operate the machine.

The Double Layer Roll Forming Machine is strictly prohibited from working beyond the minimum closing height, that is, the minimum distance from the bottom of the upper sliding box to each working surface is 290 mm. It requires the height behind the upper and lower molds plus the thickness of the upper and lower backing plates plus the thickness of the tile blank. It is not allowed to exceed 290 mm. ㎜, the mold should be designed according to this requirement to avoid machine tool accidents. In the Double Layer Roll Forming Machine, when the tile material falls between the blades of the material receiving section reamer by its own weight, the material is transported by the material receiving section reamer to the conveying section reamer, that is, into the tile cylinder. However, since the upper half of the reamer in the receiving section of the tile press is open, under the rotation of the reamer, part of the tile material is thrown away along the tangent direction of each point of the upper half of the knife and adheres to the receiving box. on the right wall. The greater the plasticity of the tiles, the more serious the adhesion phenomenon. The more adhered tiles accumulate, until the tiles are built up above the reamer in the material receiving section, making it impossible for the tiles to enter between the blades of the reamer in the material receiving section. . For a two-stage vacuum tile press, the tiles from the upper stage keep entering the vacuum box. If the scaffolding is serious, the vacuum box will be blocked and the vacuum tile press will stop working. The tile pressing device is designed to eliminate the above phenomenon. Another function of the tile pressing device is to force down the tile material within its rotation range to speed up the speed of the tile material entering the material-receiving reamer.