Outline

• I. Electrical faults

• II. Hydraulic system faults

• III. Structural faults

• IV. Safety faults

• V. Summary

 

High Altitude Roll Forming Machine platforms are indispensable and important equipment in the field of modern engineering and maintenance. However, as the usage time increases, they may encounter various faults. Timely identification and resolution of these faults are crucial to ensuring the smooth progress of work. This article will introduce the common faults and troubleshooting methods of High Altitude Roll Forming Machine platforms to help you better manage and maintain the equipment.

I. Electrical faults

Common faults:

1. The motor fails to start or stops running.

2. The control buttons on the console are inoperative.

3. The control panel shows abnormal information.

Troubleshooting methods:

1. Check whether the power contact is good and ensure that the power cable is firmly connected.

2. Check the cable and connector of the motor to ensure there is no damage or looseness.

3. Check the control panel and buttons, remove possible dust or dirt, and ensure the normal operation of the buttons.

4. If the control panel shows abnormal information, refer to the equipment manual to understand the possible fault reasons and take corresponding measures.

II. Hydraulic system faults

Common faults:

1. The lifting speed is too slow or cannot be lifted.

2. Oil leakage from the hydraulic cylinder.

3. Excessive noise from the hydraulic pump.

Troubleshooting methods:

1. Check whether the hydraulic oil level is normal. If necessary, add or replace the hydraulic oil.

2. Check whether there is any leakage in the hydraulic pipeline and connectors, and replace the damaged seals in time.

3. Check whether the filter element and oil circuit of the hydraulic pump are clean. If necessary, clean or replace the filter element.

III. Structural faults

Common faults:

1. The platform shakes or is unstable.

2. The support arm is loose or deformed.

3. The chassis wheels cannot rotate or rotate inflexibly.

Troubleshooting methods:

1. Check whether the connecting parts of the platform are loose. If necessary, tighten the screws or replace the damaged parts.

2. Regularly check the connecting bolts of the support arm to ensure firmness and reliability. If necessary, tighten or replace.

3. Clean the chassis wheels and apply an appropriate amount of lubricating oil to ensure the normal operation of the wheels.

IV. Safety faults

Common faults:

1. The emergency stop button fails.

2. The anti-overturning device is triggered.

Troubleshooting methods:

1. Check whether the emergency stop button can be started and reset normally. If necessary, clean the button and check the connecting circuit.

2. If the anti-overturning device is triggered, immediately stop using the lift and check whether the support arm is stable and remove the obstacles that may cause overturning.

V. Summary

Troubleshooting of High Altitude Roll Forming Machine platforms requires timely and accurately locating the problem and taking effective measures to repair. Regular maintenance and equipment inspection can reduce the probability of faults and ensure the safe operation of the equipment. At the same time, operators need to receive relevant training to understand the usage regulations and key points of safe operation of the lift to reduce the impact of human factors on the safety of the equipment.

If you are looking for an efficient and stable lift product, please feel free to contact us at any time, and we will serve you wholeheartedly!